[Jun-2022] Dell EMC NetWorker Expert DEA-5TT1 Exam Practice Dumps [Q16-Q31]

NEW QUESTION 16
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

Switch A Gi1/0/1

Switch A Gi1/0/2

Switch B Gi1/0/1

Switch B Gi1/0/2

NEW QUESTION 17
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

00:C4:4F

00:C4:4F:23

23:AF:4A

4F:23:AF:4A

NEW QUESTION 18
Which flags are used in the TCP header to initiate and end TCP connections or sessions?

Initiate = Acknowledge (ACK) End = Synchronize (SYN)

Initiate = Acknowledge (ACK) End = Finish (FIN)

Initiate = Synchronize (SYN) End = Finish (FIN)

Initiate = Finish (FIN)
End = Synchronize (SYN)

NEW QUESTION 19
What is the default OSPF “hello interval”?

5 seconds

10 seconds

15 seconds

30 seconds

NEW QUESTION 20
Which IEEE standard defines the Data Link Layer, Discovery protocol?

802.1AB

802.1AX

802.1D

802.1W

NEW QUESTION 21
Which type of domains are connected by a Layer 2 switch?

Single collision domain and a single broadcast domain

Multiple broadcast domains and multiple collision domains

Multiple collision domains and a single broadcast domain

Single collision domain and multiple broadcast domains

NEW QUESTION 22
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

Router

Repeater

Switch

NIC

NEW QUESTION 23
What is the aggregated lanes’ maximum speed rating for a QSFP28 transceiver?

4 Gbps

40 Gbps

112 Gbps

128 Gbps

NEW QUESTION 24
What is the valid range assigned to a client during a TCP connection?

20 – 25

443 – 1000

1023 – 2024

40000 – 65535

NEW QUESTION 25
How is a switch different from a hub?

A switch operates at a lower, more efficient layer of the OSI model.

A switch tracks MAC addresses of all connected devices.

A switch decreases the number of broadcast storms.

A switch does not include any latency into the frame transfer time.

NEW QUESTION 26
On which OSI layers do standard ACL filters operate?

2 and 3

2 and 7

3 and 4

4 and 7

NEW QUESTION 27
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

Multicast

Broadcast

Anycast

Unicast

NEW QUESTION 28
Which BASE-T Ethernet standard specifies a CAT6 cable type?

2.5GBASE-T

5GBASE-T

10BASE-T

10GBASE-T

NEW QUESTION 29
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

Store-and-forward

Fragment-free

Unicast

Cut-through

NEW QUESTION 30
On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?

Autonomous System Boundary Router (ASBR)

Area Border Router (ABR)

Designated router (DR)

Backbone Router (BR)

NEW QUESTION 31
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

Manually specify the OSPF Router ID on each switch within the path.

Break the paths into multiple OSPF areas.

Change the reference speed used by OSPF in cost calculations on all switches within the path.

Switch all routing protocols to RIPv2.