NSE7_SDW-6.4 PDF Dumps 2022 Exam Questions with Practice Test [Q12-Q31] : Actual Test Materials : http://blog.actualtests4sure.com

NO.12 Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

NO.13 Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

set cost 15.

set source 100.64.1.1.

set priority 10.

set load-balance-mode source-ip-based.

NO.14 Which statement is correct about the SD-WAN and ADVPN?

ADVPN interface can be a member of SD-WAN interface.

Dynamic VPN is not supported as an SD-Wan interface.

Spoke support dynamic VPN as a static interface.

Hub FortiGate is limited to use ADVPN as SD-WAN member interface.

NO.15 An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?

Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.

Choose the suitable interface based on the interface cost and weight.

Use the performance SLA targets to detect latency and jitter instantly.

Place the troublesome link at the top of the interface preference list.

Configure an SD-WAN rule to load balance all traffic without VoIP.

NO.16 Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.
Which two configuration changes must be made to both IPsec
VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )

Configure a unique peer ID for each dial-up VPN interface

Use unique Diffie Hellman groups on each VPN interface

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode

NO.17 Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

The debug output shows per-IP shaper values and real-time readings.

This traffic shaper drops traffic that exceeds the set limits.

Traffic being controlled by the traffic shaper is under 1 Kbps.

FortiGate provides statistics and reading based on historical traffic logs.

NO.18 What is the lnkmtd process responsible for?

Monitoring links for any bandwidth saturation

Processing performance SLA probes

Flushing route tags addresses

Logging interface quality information

NO.19 Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

The debug output shows per-IP shaper values and real-time readings.

This traffic shaper drops traffic that exceeds the set limits.

Traffic being controlled by the traffic shaper is under 1 Kbps.

FortiGate provides statistics and reading based on historical traffic logs.

NO.20 Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

NO.21 Refer to the exhibit.

What must you configure to enable ADVPN?

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one.

The protected subnets should be set to address object to all (0.0.0.0/0).

On the hub VPN, only the device needs additional phase one settings.

NO.22 What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Per-IP shaping mode

Reverse policy shaping mode

Interface-based shaping mode

Shared policy shaping mode

NO.23 Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1

SD-WAN interface becomes disabled and port1 becomes the WAN interface

Dead members require manual administrator access to bring them back alive

Port2 might become alive when a single response is received from an SLA server

NO.24 Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

NO.25 Which statement about using BGP routes in SD-WAN is true?

Adding static routes must be enabled on all ADVPN interfaces.

VPN topologies must be form using only BGP dynamic routing with SD-WAN.

Learned routes can be used as dynamic destinations in SD-WAN rules.

Dynamic routing protocols can be used only with non-encrypted traffic.

NO.26 What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NO.27 What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NO.28 Refer to exhibits.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

The reverse shaper option must be enabled and a traffic shaper must be selected

The guaranteed-10mbps option must be selected as the reverse shaper option.

A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

The guaranteed-10mbps option must be selected as the per-IP shaper option

NO.29 Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

The type of traffic defined and allowed on firewall policy ID 1 is UDP.

FortiGate has terminated the session after a change on policy ID 1.

Changes have been made on firewall policy ID 1 on FortiGate.

Firewall policy ID 1 has source NAT disabled.

NO.30 Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

A peer ID is included in the first packet from the initiator, along with suggested security policies.

XAuth is enabled as an additional level of authentication, which requires a username and password.

A total of six packets are exchanged between an initiator and a responder instead of three packets.

The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

NO.31 What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.