This page was exported from Actual Test Materials [ http://blog.actualtests4sure.com ] Export date:Fri Nov 15 22:25:30 2024 / +0000 GMT ___________________________________________________ Title: NSE7_SDW-6.4 PDF Dumps 2022 Exam Questions with Practice Test [Q12-Q31] --------------------------------------------------- NSE7_SDW-6.4 PDF Dumps 2022 Exam Questions with Practice Test Dumps for Free NSE7_SDW-6.4 Practice Exam Questions NO.12 Refer to exhibits.Exhibit A.Exhibit B.Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.Based on the exhibits, which statement is correct?  The dead member interface stays unavailable until an administrator manually brings the interface back.  The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.  Port2 needs to wait 500 milliseconds to change the status from alive to dead.  Check interval is the time to wait before a packet sent by a member interface considered as lost. NO.13 Refer to the exhibit.Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)  set cost 15.  set source 100.64.1.1.  set priority 10.  set load-balance-mode source-ip-based. NO.14 Which statement is correct about the SD-WAN and ADVPN?  ADVPN interface can be a member of SD-WAN interface.  Dynamic VPN is not supported as an SD-Wan interface.  Spoke support dynamic VPN as a static interface.  Hub FortiGate is limited to use ADVPN as SD-WAN member interface. NO.15 An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?  Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.  Choose the suitable interface based on the interface cost and weight.  Use the performance SLA targets to detect latency and jitter instantly.  Place the troublesome link at the top of the interface preference list.  Configure an SD-WAN rule to load balance all traffic without VoIP. NO.16 Refer to the exhibit.FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.Which two configuration changes must be made to both IPsecVPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )  Configure a unique peer ID for each dial-up VPN interface  Use unique Diffie Hellman groups on each VPN interface  Use different proposals are used between the interfaces.  Configure the IKE mode to be aggressive mode NO.17 Refer to the exhibit.Which two statements about the debug output are correct? (Choose two )  The debug output shows per-IP shaper values and real-time readings.  This traffic shaper drops traffic that exceeds the set limits.  Traffic being controlled by the traffic shaper is under 1 Kbps.  FortiGate provides statistics and reading based on historical traffic logs. NO.18 What is the lnkmtd process responsible for?  Monitoring links for any bandwidth saturation  Processing performance SLA probes  Flushing route tags addresses  Logging interface quality information NO.19 Refer to the exhibit.Which two statements about the debug output are correct? (Choose two )  The debug output shows per-IP shaper values and real-time readings.  This traffic shaper drops traffic that exceeds the set limits.  Traffic being controlled by the traffic shaper is under 1 Kbps.  FortiGate provides statistics and reading based on historical traffic logs. NO.20 Refer to exhibits.Exhibit A.Exhibit B.Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.Based on the exhibits, which statement is correct?  The dead member interface stays unavailable until an administrator manually brings the interface back.  The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.  Port2 needs to wait 500 milliseconds to change the status from alive to dead.  Check interval is the time to wait before a packet sent by a member interface considered as lost. NO.21 Refer to the exhibit.What must you configure to enable ADVPN?  ADVPN should only be enabled on unmanaged FortiGate devices.  Each VPN device has a unique pre-shared key configured separately on phase one.  The protected subnets should be set to address object to all (0.0.0.0/0).  On the hub VPN, only the device needs additional phase one settings. Explanation/Reference:NO.22 What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?  Per-IP shaping mode  Reverse policy shaping mode  Interface-based shaping mode  Shared policy shaping mode NO.23 Refer to exhibits.Exhibit A.Exhibit B.Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?  Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1  SD-WAN interface becomes disabled and port1 becomes the WAN interface  Dead members require manual administrator access to bring them back alive  Port2 might become alive when a single response is received from an SLA server NO.24 Refer to exhibits.Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)  All the existing sessions that do not use SNAT will be flushed and routed through port1.  All the existing sessions will continue to use port2, and new sessions will use port1.  All the existing sessions using SNAT will be flushed and routed through port1.  All the existing sessions will be blocked from using port1 and port2. NO.25 Which statement about using BGP routes in SD-WAN is true?  Adding static routes must be enabled on all ADVPN interfaces.  VPN topologies must be form using only BGP dynamic routing with SD-WAN.  Learned routes can be used as dynamic destinations in SD-WAN rules.  Dynamic routing protocols can be used only with non-encrypted traffic. Explanation/Reference:https://www.fortinetguru.com/2019/09/using-bgp-tags-with-sd-wan-rules-fortios-6-2/#:~:text=SD%2DWAN%20rules%20can%20use,to%20the%20customer’s%20data%20center.NO.26 What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )  It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.  It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.  It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.  It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager. NO.27 What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)  It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.  It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.  It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.  It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager. Explanation/Reference:NO.28 Refer to exhibits.Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?  The reverse shaper option must be enabled and a traffic shaper must be selected  The guaranteed-10mbps option must be selected as the reverse shaper option.  A new firewall policy must be created and SD-WAN must be selected as the incoming interface.  The guaranteed-10mbps option must be selected as the per-IP shaper option NO.29 Refer to the exhibit.Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?  The type of traffic defined and allowed on firewall policy ID 1 is UDP.  FortiGate has terminated the session after a change on policy ID 1.  Changes have been made on firewall policy ID 1 on FortiGate.  Firewall policy ID 1 has source NAT disabled. NO.30 Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )  A peer ID is included in the first packet from the initiator, along with suggested security policies.  XAuth is enabled as an additional level of authentication, which requires a username and password.  A total of six packets are exchanged between an initiator and a responder instead of three packets.  The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance. NO.31 What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )  It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.  It improves SD-WAN performance on the managed FortiGate devices.  It sends probe signals as health checks to the beacon servers on behalf of FortiGate.  It acts as a policy compliance entity to review all managed FortiGate devices.  It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.  Loading … Check your preparation for Fortinet NSE7_SDW-6.4 On-Demand Exam: https://www.actualtests4sure.com/NSE7_SDW-6.4-test-questions.html --------------------------------------------------- Images: https://blog.actualtests4sure.com/wp-content/plugins/watu/loading.gif https://blog.actualtests4sure.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-08-15 10:29:55 Post date GMT: 2022-08-15 10:29:55 Post modified date: 2022-08-15 10:29:55 Post modified date GMT: 2022-08-15 10:29:55