Q155. An engineer must automate certificate signing through Cisco. Which vManage configuration achieves this task?
A)

B)

C)

D)

Q156. Drag and drop the Cisco SD-WAN components from the left onto their functions on the right.

Q157. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?

Q158. In which device state does the WAN edge router create control connections, but data tunnels are not created?

Q159. An engineer is configuring a data policy for IPv4 prefixes for a single WAN Edge device on a site with multiple WAN Edge devices How is this policy added using the policy configuration wizard?

Q160. What are the two functions of vSmart? (Choose two)

Q161. Which command disables the logging of syslog messages to the local disk?

Q162. Drag and drop the devices from the left onto the correct functions on the right.

Q163. Refer to the exhibit.

A network administrator is configuring OMP in vManage to advertise all the paths for the same prefix from a site that has two WAN Edge devices Each WAN Edge device is connected to three ISPs and two private MPLS transports. What is the minimum value for ‘Number of Paths advertised per Prefix” that should be configured?

Q164. Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?
A)

B)

C)

D)

Q165. Which two mechanisms are used to guarantee the integrity of data packets in the Cisco SD-WAN architecture data plane? {Choose two)

Q166. An administrator needs to configure SD-WAN to divert traffic from the company’s private network to an ISP network. What action should be taken to accomplish this goal?

Q167.


Refer to the exhibit vManage and vBond have an issue establishing a connection with each other Which action resolves the issue?

Q168. If Smart Account Sync is not used, which Cisco SD-WAN component Is used to upload an authorized serial number file?

Q169. Refer to the exhibit.

Refer to the exhibit. Which configuration stops Netconf CLI logging on WAN Edge devices during migration?

Q170. Refer to the exhibit.

Which two configurations are needed to get the WAN Edges registered with the controllers when certificates are used? (Choose two)

Q171. Refer to the exhibit.

An engineer is troubleshooting a control connection Issue. What does “connect” mean in this how control connections output?

Q172. Drag and drop the route verification output from show omp tlocs from the left onto the correct explanations on the right.

Q173. Which logs verify when a device was upgraded?

Q174. Which scheduling method is configured by default for the eight queues in the cloud vEdge router1?

Q175. Which two products are used to deploy Cisco WAN Edge Router virtual platforms? (Choose two.)