Q37. Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

Q38. Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?

Q39. A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

Q40. On which OSI layers do standard ACL filters operate?

Q41. Which route type is added to the routing table by a routing protocol?

Q42. How many total addresses for network, broadcast, and host are provided with the subnet mask
255.255.255.240?

Q43. What accurately describes IPv6 addressing?

Q44. What is the default route preference value for a Border Gateway Protocol (BGP) internal route?

Q45. Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

Q46. What is the correct sequence of steps that occur in the communications between the client and server to obtain an IP address from a DHCP server?

Q47. Which Border Gateway Protocol (BGP) version supports IPv6?

Q48. Which port type should be used for only VLAN-unaware devices?

Q49. Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

Q50. Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

Q51. What is the default OSPF “hello interval”?

Q52. Which flags are used in the TCP header to initiate and end TCP connections or sessions?

Q53. Which type of domains are connected by a Layer 2 switch?

Q54. At which layer of the OSI model is the Rapid Spanning Tree protocol used to prevent switching loops?

Q55. What is the aggregated lanes’ maximum speed rating for a QSFP28 transceiver?

Q56. On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?

Q57. Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?