[Q12-Q30] Full FCSS_NST_SE-7.6 Practice Test and 103 unique questions with explanations waiting just for you!

Rate this post

Full FCSS_NST_SE-7.6 Practice Test and 103 unique questions with explanations waiting just for you!

Fortinet Certified Solution Specialist Dumps FCSS_NST_SE-7.6 Exam for Full Questions – Exam Study Guide

NEW QUESTION 12
Which three common FortiGate-to-collector-agent connectivity issues can you identify using the FSSO real- time debug? (Choose three.)

Log is full on the collector agent.

Inability to reach IP address of the collector agent.

Refused connection. Potential mismatch of TCP port.

Mismatched pre-shared password.

Incompatible collector agent software version.

NEW QUESTION 13
Refer to the exhibit, which shows the output of diagnose sys session list.

If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary?

The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.

Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.

The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.

The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.

NEW QUESTION 14
Refer to the exhibit.

Which route will traffic take to get to the 100.65.0.0/24 network considering the routes are all configured with the same distance?

The BGP route

The policy route

The static route

The OS PF route

NEW QUESTION 15
What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow?
(Choose two.)

Packet was dropped because of policy route misconfiguration.

Packet was dropped because of traffic shaping.

Trusted host list misconfiguration.

VIP or IP pool misconfiguration.

NEW QUESTION 16
Which two statements are true regarding heartbeat messages sent from an FSSO collector agent to FortiGate?
(Choose two.)

The heartbeat messages can be seen using the command diagnose debug authd fsso list.

The heartbeat messages can be seen in the collector agent logs.

The heartbeat messages can be seen on FortiGate using the real-lime FSSO debug.

The heartbeat messages must be manually enabled on FortiGate.

NEW QUESTION 17
Refer to the exhibit, which shows the modified output of the routing kernel.

Which statement is true?

The egress interface associated with static route 8.8.8.8/32 is administratively up.

The default static route through 10.200.1.254 is not in the forwarding information base.

The default static route through port2 is in the forwarding information base.

The BGP route to 10.0.4.0/24 is not in the forwarding information base.

NEW QUESTION 18
Exhibit.

Refer to the exhibit, which shows a partial output of diagnose hardware aysinfo memory.
Which two statements about the output are true? (Choose two.)

There are 98908 kB o! memory that will never be used.

The user space has 708880 kB of physical memory that is not used by the system.

The I/O cache, which has 641364 kB of memory allocated to it.

The value indicated next to the inactive heading represents the currently unused cache page.

NEW QUESTION 19
Refer to the exhibit.

An IPsec VPN tunnel using IKEv2 was brought up successfully, but when the tunnel rekey takes place the tunnel goes down.
The debug command for IKE was enabled and, in the exhibit, you can review the partial output of the debug IKE while attempting to bring the tunnel up.
What is causing. The tunnel to be down?

A Diffie-Hellman mismatch

Blocked traffic on UDP port 500

A mismatch m the Phase 1 negotiations

A mismatch in the Phase 2 negotiations

NEW QUESTION 20
Refer to the exhibit.

A partial output of diagnose npu up6 port-list on FortiGate 2000E is shown.
An administrator is unable to analyze traffic flowing between port1 and port17 using the diagnose sniffer command.
Which two commands allow the administrator to view the traffic? (Choose two.)

NEW QUESTION 21
Which exchange lakes care of DoS protection in IKEv2?

Create_CHILD_SA

IKE_Auth

IKE_Req_INIT

IKE_SA_NIT

NEW QUESTION 22
Refer to the exhibit, which shows the modified output of the routing kernel.

Which statement is true?

The egress interface associated with static route 8.8.8.8/32 is administratively up.

The default static route through 10.200.1.254 is not in the forwarding information base.

The default static route through port2 is in the forwarding information base.

The BGP route to 10.0.4.0/24 is not in the forwarding information base.

NEW QUESTION 23
Refer to the exhibit, which shows the output of get router info bgp summary.

Which two statements are true? (Choose two.)

The local ForliGate has received one prefix from BGP neighbor 100.64.1.254.

The TCP connection with BGP neighbor 100.64.2.254 was successful.

The local FortiGate has received 18 packets from a BGP neighbor.

The local FortiGate is still calculating the prefixes received from BGP neighbor 100.64.2.264

NEW QUESTION 24
Refer to the exhibit, which shows the output of a policy route table entry.

Which type of policy route does the output show?

An ISDB route

A regular policy route

A regular policy route, which is associated with an active static route in the FIB

An SD-WAN rule

NEW QUESTION 25
Exhibit.

Refer to the exhibit, which shows the output of get system ha status.
NGFW-1 and NGFW-2 have been up for a week.
Which two statements about the output are true? (Choose two.)

If a configuration change is made to the primary FortiGate at this time, the secondary will initiate a synchronization reset.

If port 7 becomes disconnected on the secondary, both FortiGate devices will elect itself as primary.

If FGVM…649 is rebooted. FGVM…650 will become the primary and retain that role, even after FGVM…649 rejoins the cluster.

If no action is taken, the primary FortiGate will leave the cluster because of the current sync status.

NEW QUESTION 26
Which Iwo troubleshooting steps should you perform lf you encounter issues with intermittent web filter behavior? (Choose two.)

Check that the inspection mode configured for the web filter profile matches that of the firewall policy where it is applied.

Check that FortiGate is not entering conserve mode.

Check that the correct port is mapped to HTTP in the Protocol Options

Check that the communication between FortiGate and FortiGuard is stable

NEW QUESTION 27
Exhibit.

Refer to the exhibit, which shows a partial output of diagnose hardware aysinfo memory.
Which two statements about the output are true? (Choose two.)

There are 98908 kB of memory that will never be used.

The user space has 708880 kB of physical memory that is not used by the system.

The I/O cache, which has 641364 kB of memory allocated to it.

The value indicated next to the inactive heading represents the currently unused cache page.

NEW QUESTION 28
Refer to the exhibit, which shows a partial output of a real-time LDAP debug.

What two conclusions can you draw from the output? (Choose two.)

The user was found in the LDAP tree, whose root is TAC.ottawa.fortinet.com.

FortiOS performs a bind to the LDAP server using the user’s credentials.

FortiOS collects the user group information.

FortiOS is performing the second step (Search Request) in the LDAP authentication process.

NEW QUESTION 29
Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

Strict RPF is enabled by default.

User B: Fail. There is no route to 95.56.234.24 using wan2 in the routing table.

User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.

User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.

User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.

NEW QUESTION 30
Refer to the exhibit.

The sniffer log on two FortiGate devices are shown. Based on the information in the log, which two factors explain the output on FortiGate FGT-02? (Choose two answers)

A third-party device is blocking protocol 50.

The administrator has not yet configured the VPN tunnel on FGT-02.

The administrator configured the wrong remote peer IP address on FGT-01.

The administrator set the wrong sniffer filter on FGT-02.

Fortinet FCSS_NST_SE-7.6 Exam Syllabus Topics:

Topic	Details
Topic 1	Authentication: This section evaluates the abilities of System Administrators and requires troubleshooting both local and remote authentication methods, including resolving Fortinet Single Sign-On (FSSO) problems for secure network access.
Topic 2	Routing: This section focuses on Network Engineers and involves tackling issues related to packet routing using static routes, as well as OSPF and BGP protocols to support enterprise network traffic flow.
Topic 3	Security profiles: This part measures skills of Security Operations Specialists and covers identifying and resolving problems linked to FortiGuard services, web filtering configurations, and intrusion prevention systems to maintain protection across network environments.
Topic 4	System troubleshooting: This section of the exam measures the skills of Network Security Support Engineers and addresses diagnosing and correcting issues within Security Fabric setups, automation stitches, resource utilization, general connectivity, and different operation modes in FortiGate HA clusters. Candidates work with built-in tools to effectively find and resolve faults.
Topic 5	VPN: This section is aimed at IT Professionals and includes diagnosing and addressing issues with IPsec VPNs, specifically IKE version 1 and 2, to secure remote and site-to-site connections within the network infrastructure.